Six-Head 12-Station Vertical Winding Machine (Main And Auxiliary Line Integrated Machine)
Product Characteristics
● Six-station operation and six-station waiting.
● This machine can wind the main and auxiliary coils on the same wire cup jig, reducing the labor intensity of the operator.
● The machine has no obvious vibration and noise during high-speed operation; it adopts patented technology of non-resistance cable passage.
● The bridge line is fully servo controlled, and the length can be adjusted arbitrarily.
● The machine is equipped with double turntables, with small rotating diameter, light structure, rapid shifting and precise positioning.
● Support MES network data acquisition system.
● Low energy consumption, high efficiency, low noise, long life and easy maintenance.
Product Parameter
| Product number | LRX6/12-100T |
| Flying fork diameter | 180-270mm |
| Number of working heads | 6PCS |
| Operating station | 12 Station |
| Adapt to the wire diameter | 0.17-0.8mm |
| Magnet wire material | Copper wire/aluminum wire/copper clad aluminum wire |
| Bridge line processing time | 4S |
| Turntable conversion time | 1.5S |
| Applicable motor pole number | 2、4、6、8 |
| Adapt to the stator stack thickness | 13mm-45mm |
| Maximum stator inner diameter | 80mm |
| Maximum speed | 3000-3500 Laps/minute |
| Air pressure | 0.6-0.8MPA |
| Power supply | 380V three-phase four-wire system 50/60Hz |
| Power | 15kW |
| Weight | 4500kg |
| Dimensions | (L) 2980* (W) 1340* (H) 2150mm |
FAQ
Problem : Diaphragm Diagnosis
Solution:
Reason 1. Insufficient negative pressure of the detection meter will result in the failure to reach the set value and cause signal loss. Adjust the negative pressure setting to a suitable level.
Cause 2. The diaphragm size may not match the diaphragm clamp, preventing proper operation. A matching diaphragm is recommended.
Reason 3. Air leakage in the vacuum test may be caused by improper placement of the diaphragm or fixture. Orient the diaphragm correctly, clean the clamps, and make sure everything is correct.
Reason 4. A clogged or faulty vacuum generator will reduce the suction and negatively affect the negative pressure value. Clean the generator to fix the problem.
Problem: When playing a reversible movie with sound, the cylinder can only move up and down.
Solution:
When the sound film advances and retreats, the cylinder sensor detects a signal. Check sensor location and adjust if necessary. If the sensor is damaged, it should be replaced.
